Product Overview
Aegis® H100NP is a medium viscosity, nylon 6 extrusion grade homopolymer for cast or blown film. It conforms to FDA requirements of 21 CFR 177.1500 as well as EU Directive 2011/10/EC. It possesses the combination of strength, toughness and thermoforming properties associated with Nylon 6 as well as excellent heat, chemical, and abrasion resistance. Processing Methods: Extrusion, film extrusion, thermoforming, cast film extrusion, blown film extrusion, pipe, profile and tubing extrusion
Product Identity
| Chemical name | Nylon |
|---|---|
| Chemical composition | Polyamide 6 (PA 6) |
Processing & Availability
- Additional product information
- Material Handling
- Additional product information
- Aegis® H100NP homopolymer is supplied in sealed containers and drying prior to processing is not required. However, high
- Additional product information
- moisture is the primary cause of processing problems. If drying becomes necessary, a dehumidifying or desiccant dryer
- Additional product information
- operating at 80°C (176°F) is recommended. Drying time is dependent on moisture level. Further information concerning safe
- Additional product information
- handling procedures can be obtained from the Safety Data Sheet. Alternatively, please contact your AdvanSix representative.
- Additional product information
- Extrusion Guidelines
- Additional product information
- Melt Viscosity vs. Temperature
- Additional product information
- Melt Temperature: 220°C (428°F)
- Additional product information
- Melt Temperature Range: 232°C (450°F) to 271°C (520°F)
- Additional product information
- Two key factors affect the melt viscosity (stiffness or fluidity of the melt):
- Additional product information
- 1. The molecular weight (Mw) of the resin: Higher Mw resins will have a higher melt viscosity than lower Mw resins.
- Additional product information
- 2. Temperature of the melt for any given Mw resin: Higher process temperatures will provide a more fluid melt viscosity than lower process temperatures.
- Additional product information
- Typical Barrel Profile for Cast Films
- Additional product information
- Barrel: 230-260°C (446-500°F)
- Additional product information
- Adapter: 260-266°C (500-510°F)
- Additional product information
- Die: 260°C (500°F)
- Additional product information
- Process Melt Temperature: 260-270°C (500-518°F)
- Additional product information
- Typical Barrel Profile for Tubular (Blown) Films
- Additional product information
- Barrel: 246-254°C (474-490°F)
- Additional product information
- Adapter: 260°C (500°F)
- Additional product information
- Die: 254°C (490°F)
- Additional product information
- Process Melt Temperature: 254-260°C (490-500°F)
- Additional product information
- Screw Parameters
- Additional product information
- Metering Section: 40%
- Additional product information
- Transition Section: 3 to 4 flights
- Additional product information
- Feed Section: Balance of screw length
- Additional product information
- Compression Ratio: 3.5:1 to 4.0:1
- Additional product information
- L/D Ratio: 24:1
Technical Documents & Source References
No technical PDF is referenced in the source record for this product.